Filter
Top Products
Chapter 9 Monitor
ZyWALL USG 50 User’s Guide
184
Connected
Device
This field displays the model name of the cellular card.
Status No device - no 3G device is connected to the ZyWALL.
No Service - no 3G network is available in the area; you cannot
connect to the Internet.
Limited Service - returned by the service provider in cases where the
SIM card is expired, the user failed to pay for the service and so on;
you cannot connect to the Internet.
Device detected - displays when you connect a 3G device.
Device error - a 3G device is connected but there is an error.
Probe device fail - the ZyWALL’s test of the 3G device failed.
Probe device ok - the ZyWALL’s test of the 3G device succeeded.
Init device fail - the ZyWALL was not able to initialize the 3G device.
Init device ok - the ZyWALL initialized the 3G card.
Check lock fail - the ZyWALL’s check of whether or not the 3G device
is locked failed.
Device locked - the 3G device is locked.
SIM error - there is a SIM card error on the 3G device.
SIM locked-PUK - the PUK is locked on the 3G device’s SIM card.
SIM locked-PIN - the PIN is locked on the 3G device’s SIM card.
Unlock PUK fail - Your attempt to unlock a WCDMA 3G device’s PUK
failed because you entered an incorrect PUK.
Unlock PIN fail - Your attempt to unlock a WCDMA 3G device’s PIN
failed because you entered an incorrect PIN.
Unlock device fail - Your attempt to unlock a CDMA2000 3G device
failed because you entered an incorrect device code.
Device unlocked - You entered the correct device code and unlocked
a CDMA2000 3G device.
Get dev-info fail - The ZyWALL cannot get cellular device information.
Get dev-info ok - The ZyWALL succeeded in retrieving 3G device
information.
Searching network - The 3G device is searching for a network.
Get signal fail - The 3G device cannot get a signal from a network.
Network found - The 3G device found a network.
Apply config - The ZyWALL is applying your configuration to the 3G
device.
Inactive - The 3G interface is disabled.
Active - The 3G interface is enabled.
Incorrect device - The connected 3G device is not compatible with
the ZyWALL.
Correct device - The ZyWALL detected a compatible 3G device.
Set band fail - Applying your band selection was not successful.
Set band ok - The ZyWALL successfully applied your band selection.
Set profile fail - Applying your ISP settings was not successful.
Set profile ok - The ZyWALL successfully applied your ISP settings.
PPP fail - The ZyWALL failed to create a PPP connection for the cellular
interface.
Need auth-password - You need to enter the password for the 3G
card in the cellular edit screen.
Device ready - The ZyWALL successfully applied all of your
configuration and you can use the 3G connection.
Table 35 Monitor > System Status > Cellular Status (continued)
LABEL DESCRIPTION