Filter
Top Products
Chapter 13 Policy and Static Routes
ZyWALL USG 50 User’s Guide
285
The following table describes the labels in this screen.
Table 76 Configuration > Network > Routing > Policy Route
LABEL DESCRIPTION
Show Advance
Settings /
Hide Advance
Settings
Click this button to display a greater or lesser number of configuration
fields.
Enable BWM This is a global setting for enabling or disabling bandwidth management
on the ZyWALL. You must enable this setting to have individual policy
routes or application patrol policies apply bandwidth management.
This same setting also appears in the AppPatrol > General screen.
Enabling or disabling it in one screen also enables or disables it in the
other screen.
Use Policy
Route to
Override
Direct Route
Select this to have the ZyWALL forward packets that match a policy route
according to the policy route instead of sending the packets directly to a
connected network. See Section 6.4.1 on page 92 for how this option
affects the routing table.
Add Click this to create a new entry. Select an entry and click Add to create a
new entry after the selected entry.
Edit Double-click an entry or select it and click Edit to open a screen where
you can modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Move To change a rule’s position in the numbered list, select the rule and click
Move to display a field to type a number for where you want to put that
rule and press [ENTER] to move the rule to the number that you typed.
The ordering of your rules is important as they are applied in order of
their numbering.
# This is the number of an individual policy route.
Status This icon is lit when the entry is active, red when the next hop’s
connection is down, and dimmed when the entry is inactive.
User This is the name of the user (group) object from which the packets are
sent. any means all users.
Schedule This is the name of the schedule object. none means the route is active
at all times if enabled.
Incoming This is the interface on which the packets are received.
Source This is the name of the source IP address (group) object. any means all
IP addresses.
Destination This is the name of the destination IP address (group) object. any means
all IP addresses.