Filter
Top Products
Chapter 14 Routing Protocols
ZyWALL USG 50 User’s Guide
306
14.3.2 OSPF Area Add/Edit Screen
The OSPF Area Add/Edit screen allows you to create a new area or edit an
existing one. To access this screen, go to the OSPF summary screen (see Section
14.3 on page 299), and click either the Add icon or an Edit icon.
Figure 185 Configuration > Network > Routing > OSPF > Add
The following table describes the labels in this screen.
Table 85 Configuration > Network > Routing > OSPF > Add
LABEL DESCRIPTION
Area ID Type the unique, 32-bit identifier for the area in IP address format.
Type Select the type of OSPF area.
Normal - This area is a normal area. It has routing information about
the OSPF AS and about networks outside the OSPF AS.
Stub - This area is an stub area. It has routing information about the
OSPF AS but not about networks outside the OSPF AS. It depends on a
default route to send information outside the OSPF AS.
NSSA - This area is a Not So Stubby Area (NSSA), per RFC 1587. It has
routing information about the OSPF AS and networks that are outside
the OSPF AS and are directly connected to the NSSA. It does not have
information about other networks outside the OSPF AS.
Authentication Select the default authentication method used in the area. This
authentication protects the integrity, but not the confidentiality, of
routing updates.
None uses no authentication.
Text uses a plain text password that is sent over the network (not very
secure).
MD5 uses an MD5 password and authentication ID (most secure).