Filter
Top Products
Chapter 22 Firewall
ZyWALL USG 50 User’s Guide
373
User Select a user name or user group to which to apply the rule. The rule is
activated only when the specified user logs into the system and the rule
will be disabled when the user logs out.
Otherwise, select any and there is no need for user logging.
Note: If you specified an IP address (or address group) instead of
any in the field below, the user’s IP address should be within
the IP address range.
Address Select a source address or address group for whom this rule applies.
Select any if the policy is effective for every source address.
Session Limit
per Host
Use this field to set a limit to the number of concurrent NAT/firewall
sessions this rule’s users or addresses can have.
For this rule’s users and addresses, this setting overrides the Default
Session per Host setting in the general Firewall Session Limit
screen.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
Table 110 Configuration > Firewall > Session Limit > Edit (continued)
LABEL DESCRIPTION