Filter
Top Products
Appendix A Log Descriptions
ZyWALL USG 50 User’s Guide
814
The policy route %d
uses empty user group!
Use an empty object group.
%d: the policy route rule number
The policy route %d
uses empty source
address group!
Use an empty object group.
%d: the policy route rule number
The policy route %d
uses empty destination
address group!
Use an empty object group.
%d: the policy route rule number
The policy route %d
uses empty service
group
Use an empty object group.
%d: the policy route rule number
Policy-route rule %d
was inserted.
Rules is inserted into system.
%d: the policy route rule number
Policy-route rule %d
was appended.
Rules is appended into system.
%d: the policy route rule number
Policy-route rule %d
was modified.
Rule is modified.
%d: the policy route rule number
Policy-route rule %d
was moved to %d.
Rule is moved.
1st %d: the original policy route rule number
2nd %d: the new policy route rule number
Policy-route rule %d
was deleted.
Rule is deleted.
%d: the policy route rule number
Policy-route rules
were flushed.
Policy routing rules are cleared.
BWM has been
activated.
The global setting for bandwidth management on the ZyWALL
has been turned on.
BWM has been
deactivated.
The global setting for bandwidth management on the ZyWALL
has been turned off.
Interface %s alive,
related policy route
rules will be re-
enabled
An interface came back up so the ZyWALL will use the related
policy route rules again.
Interface %s dead,
related policy route
rules will be disabled
An interface went down so the ZyWALL will stop using the
related policy route rules.
Trunk %s alive,
related policy route
rules will be re-
enabled
A trunk came back up so the ZyWALL will use the related
policy route rules again.
Trunk %s dead, related
policy route rules
will be disabled
A trunk went down so the ZyWALL will stop using the related
policy route rules.
Table 266 Policy Route Logs (continued)
LOG MESSAGE DESCRIPTION