Filter
Top Products
Chapter 13 Policy and Static Routes
ZyWALL USG 50 User’s Guide
292
The following table describes the labels in this screen.
13.3.1 Static Route Add/Edit Screen
Select a static route index number and click Add or Edit. The screen shown next
appears. Use this screen to configure the required information for a static route.
Figure 178 Configuration > Network > Routing > Static Route > Add
The following table describes the labels in this screen.
Table 78 Configuration > Network > Routing > Static Route
LABEL DESCRIPTION
Add Click this to create a new static route.
Edit Double-click an entry or select it and click Edit to open a screen where
you can modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
# This is the number of an individual static route.
Destination This is the destination IP address.
Subnet Mask This is the IP subnet mask.
Next-Hop This is the IP address of the next-hop gateway or the interface through
which the traffic is routed. The gateway is a router or switch on the same
segment as your ZyWALL's interface(s). The gateway helps forward
packets to their destinations.
Metric This is the route’s priority among the ZyWALL’s routes. The smaller the
number, the higher priority the route has.
Table 79 Configuration > Network > Routing > Static Route > Add
LABEL DESCRIPTION
Destination IP This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
Subnet Mask Enter the IP subnet mask here.