Filter
Top Products
Chapter 11 Interfaces
ZyWALL USG 50 User’s Guide
249
11.6.2 VLAN Add/Edit
This screen lets you configure IP address assignment, interface bandwidth
parameters, DHCP settings, and connectivity check for each VLAN interface. To
access this screen, click the Add icon at the top of the Add column or click an
Edit icon next to a VLAN interface in the VLAN Summary screen. The following
screen appears.
Object
References
Select an entry and click Object References to open a screen that shows
which settings use the entry. See Section 11.3.2 on page 230 for an
example.
# This field is a sequential value, and it is not associated with any interface.
Status This icon is lit when the entry is active and dimmed when the entry is
inactive.
Name This field displays the name of the interface.
Port/VID For VLAN interfaces, this field displays
• the Ethernet interface on which the VLAN interface is created
• the VLAN ID
For virtual interfaces, this field is blank.
IP Address This field displays the current IP address of the interface. If the IP address is
0.0.0.0, the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address
(STATIC) or dynamically assigned (DHCP). IP addresses are always static
in virtual interfaces.
Mask This field displays the interface’s subnet mask in dot decimal notation.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 62 Configuration > Network > Interface > VLAN (continued)
LABEL DESCRIPTION