Filter
Top Products
Chapter 23 IPSec VPN
ZyWALL USG 50 User’s Guide
379
SA). Click a column’s heading cell to sort the table entries by that column’s
criteria. Click the heading cell again to reverse the sort order.
Figure 229 Configuration > VPN > IPSec VPN > VPN Connection
Each field is discussed in the following table. See Section 23.2.2 on page 387 and
Section 23.2.1 on page 380 for more information.
Table 112 Configuration > VPN > IPSec VPN > VPN Connection
LABEL DESCRIPTION
Use Policy
Route to
control
dynamic
IPSec rules
Select this to be able to use policy routes to manually specify the
destination addresses of dynamic IPSec rules. You must manually create
these policy routes. The ZyWALL automatically obtains source and
destination addresses for dynamic IPSec rules that do not match any of
the policy routes.
Clear this to have the ZyWALL automatically obtain source and
destination addresses for all dynamic IPSec rules.
See Section 6.4.1 on page 92 for how this option affects the routing table.
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where
you can modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Connect To connect an IPSec SA, select it and click Connect.
Disconnect To disconnect an IPSec SA, select it and click Disconnect.
# This field is a sequential value, and it is not associated with a specific
connection.