Filter
Top Products
Workman HD Series Page 6 − 39 Drive Train
Transaxle Assembly
1. Clean gasket material from all mating surfaces be-
fore reassembling. Make sure all parts are clean and
free of dirt and dust.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
2. Assemble L.H. axle shaft:
A. Install new oil seal into differential carrier.
B. Use a press to install bearing onto L.H. axle shaft.
C. Install washer and snap ring.
D. Install L.H. axle shaft assembly into differential
carrier.
E. Install snap ring.
F. Install new O−ring. Apply multi−purpose grease
on O−ring before installing.
3. Assemble R.H. axle shaft:
A. Install new oil seal into seal cover. Apply multi−
purpose grease on O−ring before installing.
B. Insert washer.
C. Use a press to install bearing onto R.H. axle shaft.
D. Install washer and snap ring.
E. Install R.H. axle shaft assembly into seal cover.
L.H. SHAFT
R.H. SHAFT
1. O−ring
2. Snap ring
3. L.H. axle shaft assembly
4. Snap ring
5. Washer
6. Bearing
7. Oil seal
8. Differential carrier
9. R.H. axle shaft assembl
y
10. Snap ring
11. Washer
12. Bearing
13. Oil seal
14. Washer
15. Seal cover
Figure 65
5
6
7
4218 3
11 14 9
10 12
15 13
4. Assemble differential fork shaft:
A. Drive lock pins into fork shaft. Make sure lock pins
are installed with slit facing the correct direction.
B. Install fork, spring, washer and snap ring onto
fork shaft using a press. Apply moly disulfide grease
onto fork portion of fork shaft before installing.
C. Install new O−ring. Apply multi−purpose grease
on O−ring before installing.
1. O−ring
2. Snap ring
3. Washer
4. Spring
5. Fork
6. Lock pin
7. Fork shaft
Figure 66
6
543217
ARM
LOCK PIN