Filter
Top Products
Workman HD SeriesPage 7 − 34Chassis
Rear Leaf Spring
13
12
14
11
10
3
6
8
9
5
1
4
2
7
12
10
12
12
5
5
12
See tightening
procedure in text
1. Washer (4 per plate)
2. Spring mount (LH shown)
3. Rear frame
4. Flange head screw
5. Flange nut
6. Rear axle
7. Axle bumper (2)
8. Lock nut
9. Bolt (4 per plate)
10. Spring shackle (2 per spring)
11. Spring plate (2)
12. Rubber bushing (6 per spring)
13. Leaf spring (2)
14. Lock nut
Figure 27
FRONT
RIGHT
IMPORTANT: For proper vehicle performance, al-
ways replace the springs on both sides of the ve-
hicle.
Removal (Fig. 27)
1. Park vehicle on a level surface, shut engine off, re-
move key from ignition switch and apply parking brake.
2. Jack up and support rear of vehicle with jack stands
(See Jacking Vehicle in Chapter 1 − Safety).
3. Remove rear wheels (see Wheel Assembly Remov-
al in this section).
4. Support rear axle to prevent it from moving during
leaf spring removal.
5. Remove four (4) bolts and washers securing leaf
spring to rear axle.
6. Remove two (2) flange nuts from spring shackles.
Remove spring shackles from leaf spring and frame.
7. Remove two (2) lock nuts and flange head screws
securing spring mount to frame rail, then remove leaf
spring assembly.