Filter
Top Products
Workman HD Series Page 6 − 53 Drive Train
31.Install R.H. axle shaft assembly:
A. Apply silicone sealant onto mating surface of seal
cover.
B. Install axle shaft assembly and secure with four
(4) flange head screws. Torque screws from 18.5 to
22 ft−lb (24.5 to 29.5 N−m).
1
2
1. Flange head screw (4) 2. Axle shaft assembly
Figure 105
18.5 to 22 ft−lb
(24.5 to 29.5 N−m)
32.Install L.H. axle shaft assembly:
A. Thoroughly clean mating surface of differential
carrier and side cover.
B. Insert selected shims into housing of side cover.
NOTE: The thickest shim should be installed
against the bearing.
1
2
1. Mating surface 2. Shim
Figure 106
C. Install axle shaft assembly and secure with flange
head screws. Torque screws from 18.5 to 22 ft−lb
(24.5 to 29.5 N−m).
1
1. Flange head screw (5)
Figure 107
18.5 to 22 ft−lb
(24.5 to 29.5 N−m)