Filter
Top Products
Workman HD SeriesPage 6 − 50Drive Train
25.Measure countershaft end play. Rotate one of the
axle shafts back and forth to take up all back lash. Rotat-
ing the shaft in one direction will pull the shaft and bear-
ing away from the snap ring. Rotate axle shaft in this
direction, then measure space between the snap ring
and shim (set) with a feeler gauge. Make sure shim (set)
is held against the bearing during the measurement.
End play should be from 0.000 to 0.0039 in. (0.00 to 0.10
mm).
IMPORTANT: If end play is too large, replace shim/
shim set with thicker shims to reduce end play.
Figure 96
26.Insert sealing cap flush with face of housing. Make
sure to not insert sealing cap too far. Pay attention to
direction of sealing cap.
1
1. Sealing cap
Figure 97
27.Install fork shaft case:
A. Insert spindle between fork shafts.
1
1. Spindle
Figure 98
Drive Train