Filter
Top Products
Workman HD SeriesPage 6 − 24Drive Train
7. Loosen and remove fifteen (15) flange head screws
and separate center plate from transaxle case. Note
dowel pins in transaxle case. Remove seal cap, shims
and snap ring from center plate.
1
3
2
4
1. Seal cap
2. Shims
3. Shim
4. Snap ring
Figure 27
8. 4WD UNITS ONLY: remove front drive shaft and 41T
gear from the gear case. Remove bearings from gear
case and center plate (Fig. 28 and Fig. 29).
1
1. Front drive shaft
2. 41T gear
3. Bearing (gear case)
4. Bearing (center plate)
Figure 28
2
3
4
9. Remove reverse shaft from transaxle case.
1
2
1. Reverse shaft 2. Bearing (gear case)
Figure 29
Drive Train