Filter
Top Products
Workman HD SeriesPage 9 − 52Hydraulic System
Steering Control Valve
1. Lock nut
2. Flat washer
3. Steering wheel
4. Steering control valve
5. Hyd hose (to control valve E port)
6. Hyd hose (to control valve T port)
7. Hyd hose (to control valve P port)
8. Hyd hose (to control valve L port)
9. Hyd hose (to control valve R port)
10. Cap screw (4)
11. Dust cover
12. Steering hose cover
13. Cable tie
14. Bulkhead fitting (to valve L port)
15. Bulkhead fitting (to valve R port)
16. Bulkhead fitting (to valve T port)
17. Bulkhead fitting (to valve P port)
18. Bulkhead fitting (to valve E port)
19. Hyd hose (to steer cyl shaft end)
20. Hyd hose (to steer cyl barrel end)
Figure 39
FRONT
RIGHT
1
2
3
4
5
6
7
8
9
10
11
12
13
19
20
Antiseize
Lubricant
20 to 25 ft−lb
(28 to 33 N−m)
14
15
16
17
18
Removal (Fig. 39)
1. Park vehicle on a level surface, shut engine off and
engage the parking brake. Remove key from the ignition
switch.
2. Remove steering wheel (see Steering Wheel Re-
moval in Chapter 7 − Chassis in this manual).
3. Remove cable ties that secure steering hose cover
to hydraulic hoses. Remove cover from hoses.
4. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of this chapter section.