Filter
Top Products
Workman HD Series Page 7 − 39 Chassis
Removal (Fig. 30)
1. Park vehicle on a level surface, raise and support
bed (if installed), shut engine off and apply the parking
brake. Remove key from ignition switch.
2. Remove six (6) carriage screws and flange nuts that
secure ROPS cover to ROPS frame. Remove cover
from vehicle (Fig. 31).
3. Remove knobs from control levers, then remove
center console control plate assembly.
4. Remove four (4) socket head screws that secure
each seat to vehicle. Lift both seats from vehicle.
5. Lift engine coolant overflow tank from slots in rear of
seat base. Position overflow tank away from seat base.
6. Carefully lift seat base from vehicle.
Installation (Fig. 30)
1. Lower seat base to vehicle while guiding control lev-
ers through seat base opening.
2. Secure seats to vehicle with removed fasteners.
3. Secure engine coolant overflow tank into slots in rear
of seat base.
4. Secure center console control plate to seat base with
removed screws. Install knobs on control levers.
5. Install ROPS cover to vehicle (Fig. 31).
Figure 31
1. ROPS frame
2. Carriage screw (6)
3. Flange nut (6)
4. ROPS cover
5. Seal (2)
FRONT
RIGHT
1
2
3
4
2
3
3
2
2
4
Chassis