Filter
Top Products
Workman HDX/HDX−D Page 10 − 15 Front Wheel Drive (4WD)
Front Differential Disassembly
1. Make sure that the oil is drained from the differential
assembly.
2. Remove the four (4) flange head screws from the in-
put cover. Remove the cover.
1. Input cover 2. Pinion shaft
Figure 11
2
1
3. Remove the pinion shaft from housing by pulling it
out of the gear case by hand.
1. Pinion shaft 2. Gear case
Figure 12
2
1
4. Inspect the inner pinion bushing in the gear case. If
the bushing is excessively worn, the gear case must be
replaced. The bushing is not serviced separately.
1. Pinion bushing
Figure 13
1
Front Wheel
Drive (4WD)