Filter
Top Products
Workman HD Series Page 6 − 61 Drive Train
Inspection
1. Thoroughly clean and dry all parts.
2. Use emery cloth to remove nicks and burrs from all
parts.
3. Measure clearance between groove on shift collar
and shifter block. Replace shifter block if clearance ex-
ceeds 0.039 in. (1.0 mm).
CLEARANCE
Figure 124
4. Measure I.D. of input shaft bushing. Replace bush-
ing if I.D. exceeds 0.673 in. (17.10 mm).
1
1. Input shaft bushing
Figure 125
5. Measure O.D. of bushing area on input shaft. Re-
place shaft if O.D. is less than 0.667 in. (16.95 mm). In-
spect surface of bushing area for scoring or damage.
BUSHING
AREA
Figure 126
6. Inspect surface of oil seal area on output shaft for
wear or damage.
OIL SEAL
AREA
Figure 127
Drive Train