Filter
Top Products
Workman HD SeriesPage 6 − 48Drive Train
20.Install reverse shaft into transaxle case. Rotate main
shaft and reverse shaft gears to mesh gears when
installing.
1
2
1. Reverse shaft 2. Bearing (gear case)
Figure 90
21.4WD UNITS ONLY: Install bearing to gear case and
center plate. Install front drive shaft and 41T gear to the
gear case.
1
1. Front drive shaft
2. 41T gear
3. Bearing (gear case)
4. Bearing (center plate)
Figure 91
2
3
4
22.Install center plate:
A. Insert dowel pins into transaxle case.
B. Apply silicone sealant onto mating surface of
center plate.
C. Position center plate to transaxle.
D. Install and tighten fifteen (15) flange head screws
to a torque from 18.5 to 22 ft−lb (24.5 to 29.5 N−m).
E. Apply multi−purpose grease onto lips of oil seal,
then insert oil seal flush with face of housing.
F. Apply moly disulfide grease to spline of main
shaft for clutch disk hub.
Figure 92
18.5 to 22 ft−lb
(24.5 to 29.5 N−m)
Drive Train