Toro HD 07369 S?N 3140000001 & up Work Light User Manual


 
Workman HD Series
Page 1 − 5
Safety
Jacking Vehicle
When changing attachments, tires or perform-
ing other service, use correct jacks, hoists and
jack stands. Always chock or block the wheels
and use jack stands to support the vehicle. If
the vehicle is not properly supported by jack
stands, the vehicle may move or fall resulting
in personal injury.
WARNING
1. Do not start engine while vehicle is on jack, because
engine vibration or wheel movement could cause ve-
hicle to slip off jack.
2. Do not work under vehicle without jack stands sup-
porting it. The vehicle could slip off jack, injuring any one
beneath it.
3. The jacking point at the front of the vehicle is under
the front center frame support (Fig. 1). When jacking up
front of vehicle, always place a wood block (or similar
material) between jack and vehicle frame support.
4. The jacking point at the rear of the vehicle is under
the axle tube (Fig. 2).
Figure 1
1. Front jacking point
1
Figure 2
1. Rear jacking point
1
Safety