Filter
Top Products
Workman HD SeriesPage 6 − 44Drive Train
10.Assemble reduction shaft:
A. Install thrust washer (item 17), needle bearings
and gear onto reduction shaft. Apply moly disulfide
grease to washer and needle bearings before instal-
ling. Oil groove on washer must face the gear.
B. Install synchro ring onto gear. Apply clean Dex-
ron III transmission oil on cone face of gear before
installing synchro ring.
C. Insert key onto reduction shaft.
D. Install synchro hub sub−assembly.
E. Install snap ring.
F. Install spacer onto gear.
G. Insert needle bearings into gear.
H. Install washer. Oil groove on washer must face
the gear.
I. Use a press to install bearing.
1. Bearing
2. Gear
3. Helical gear
4. Collar
5. Gear
6. Bearing
7. Washer
8. Gear
9. Needle bearing
10. Spacer
11. Snap ring
12. Shifter
13. Key
14. Synchro ring
15. Gear
16. Needle bearing
17. Thrust washer
18. Reduction shaft
1
3
5
15 14
13 10
7
18
2
4
17 16
12
11
9
8
6
Figure 78
1
2
3
4
5
18
13
17
16
15
14
12
11
8
9
7
6
Figure 79
1. Bearing
2. Gear
3. Helical gear
4. Collar
5. Gear
6. Bearing
7. Washer
8. Gear
9. Needle bearing
10. Spacer
11. Snap ring
12. Shifter
13. Key
14. Synchro ring
15. Gear
16. Needle bearing
17. Thrust washer
18. Reduction shaft
Drive Train