Filter
Top Products
Workman HD Series Page 6 − 27 Drive Train
17.Remove washer from inside of transaxle case.
NOTE: Washer may stick to fork shaft when removed in
step 16.
1
1. Washer
Figure 36
18.To remove shift arms:
A. Loosen and remove nut. Remove 2nd−3rd shift
arm together with shift arm plate, spring, lock nut,
washer and cap screw.
B. Loosen and remove lock nut from both 1st−Rev.
shift arm and High−Low shift arm (not shown). Re-
move shift arms.
C. Loosen cap screws (Fig. 38) and remove keeper
plates.
D. Remove oil seals.
E. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
8
5
7
6
4
3
9
1
2
1. Nut
2. 2
nd
−3
rd
shift arm
3. Shift arm plate
4. Spring
5. Lock nut
6. Washer
7. Cap screw
8. Lock nut
9. 1st−Rev shift arm
Figure 37
12
10
11
10. Cap screw
11. Keeper plate
12. Oil seal
Figure 38
Drive Train