Filter
Top Products
4-14
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove a Slot Cover
Figure 4-12 Switch Fabric Slot (Half Height) Slot Cover
Prerequisites
Before performing this task, remove any cosmetic covers and ensure that the slot over which you are
about to install the cover is empty. See the “Removing an RP, PRP, or DRP Card” section on page 4-41
and the “Removing a Switch Fabric Card” section on page 4-26.
Required Tools and Equipment
You need the following tools and part to perform this task:
• ESD-preventive wrist strap
• Large Phillips screwdriver
• Slot cover
Steps
To install a slot cover, follow these steps:
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
on the rear (MSC) side or a bare metal surface on the chassis.
Step 2 Using the handle, hold the slot cover in place over the slot.
122142