Filter
Top Products
4-31
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove an MSC, FP, or LSP
Prerequisites
Note See Chapter 1, “Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Overview,” for information
on MSC slot types, numbers, widths, and locations.
Caution Remove or install only one line card at a time. Allow at least 15 seconds for the router to complete the
preceding tasks before removing or installing another line card. The router may indicate a hardware
failure if you do not follow proper procedures.
Caution Do not carry an MSC by the bracket attached to the faceplate.
Required Tools and Equipment
You need the following tools and part to perform this task:
• ESD-preventive strap
• Medium flat-blade or Phillips screwdriver
• MSC, FP, or LSP line card (see the product data sheet for ordering details).
Steps
To install a line card, see Figure 4-23 and follow these steps: