Filter
Top Products
4-55
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
How to Install or Remove a Small Form-Factor Pluggable (SFP)
Module
This section contains the following procedures:
• Installing a Bale-Clasp SFP Module, page 4-55
• Removing a Bale-Clasp SFP Module, page 4-56
• Replacing a SFP on a Line Card that Uses an Articulated Bracket, page 4-59
For general information about SFP modules, see the “Information About Small Form-Factor Pluggable
(SFP) Modules” section on page 4-12. For information on SFP optical cleaning, see “Inspection and
Cleaning Procedures for Fiber-Optic Connections,” at the following URL:
http://www.cisco.com/warp/public/127/cleanfiber2.html
Warning
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures.
Statement 70
Installing a Bale-Clasp SFP Module
This section describes how to install a bale-clasp SFP module. The module has a clasp used to install
and remove the module (see Figure 4-36).
Figure 4-36 Bale-Clasp SFP Module
Prerequisites
Before installing a module, remove any front cover plates.
Required Tools and Equipment
You need the following tools and part to perform this task:
• ESD-preventive wrist strap
• Bale-clasp SFP module
Steps
To install a bale-clasp SFP module (into a PLIM), follow these steps:
63067