Filter
Top Products
5-9
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 5 Installing and Removing Exterior Components
Installing or Removing the Front Side Exterior Components
What to Do Next
Be sure that all parts have been carefully set aside and repackaged appropriately. If you have ordered the
front cover for the 8-slot chassis, proceed to the next section for installation instructions.
Installing the Front Cover
This section describes how to install the front cover. The front cover protects the card cage on the front
(PLIM) side of the chassis.
Figure 5-5 shows the front cover installed on the Cisco CRS 8-slot line card chassis.
Figure 5-5 Front Cover Installed on Chassis
Prerequisites
Before installing the front cover, you should mount the chassis in a rack and remove the rear handle pulls.
See Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Unpacking, Moving, and Securing
Guide.
Required Tools and Equipment
• ESD-preventive wrist strap
• Large Phillips screwdriver
• Front cover (Cisco product number: CRS-8-FRONT-COVER=)
CISCO CRS-1
SERIES
LINEC ARD CH ASS IS
254852