Filter
Top Products
4-56
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove a Small Form-Factor Pluggable (SFP) Module
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
on the front (PLIM) side or a bare metal surface on the chassis.
Step 2 Close the bale clasp before inserting the module.
Step 3 Align the module with the port and slide it into the port (see Figure 4-37).
Note Be careful to hold the module in such a way so as to not damage the bale clasp.
Figure 4-37 Installing a Bale-Clasp SFP Module into a Port
What to Do Next
After performing this task, replace any front cover plates.
Removing a Bale-Clasp SFP Module
This section describes how to remove a bale-clasp SFP module. The module has a clasp used to install
and remove the module (see Figure 4-38).
116294