Filter
Top Products
4-32
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove an MSC, FP, or LSP
Figure 4-23 Installing an MSC
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
on the rear (MSC) side or a bare metal surface on the chassis.
Step 2 Choose an available MSC slot for the MSC.
Caution To prevent ESD damage, handle a line card by its ejector levers or the card carrier edges only.
Do not touch any of the electrical components, pins, or circuitry.
Step 3 Remove the MSC impedance carrier from the slot you need to fill and set it aside.
Note Remove only one impedance carrier and install one MSC at a time. Be sure to verify that each
line card is fully installed and secured before installing another card.
Step 4 Remove the line card you are installing from its antistatic packaging.
1 Captive screw 3 Direction of installation or removal
2 Ejector lever
3
122922
1
2