Filter
Top Products
4-34
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove an MSC, FP, or LSP
Prerequisites
Note For information on MSC slot types, numbers, widths, and locations see Chapter 1, “Cisco CRS Carrier
Routing System 8-Slot Line Card Chassis Overview.”
Caution Use the cable management bracket to slide cards from the card carrier. Do not lift cards by the cable
management bracket! Rotate cards onto their vertical axes, then lift them from the bottom, using the
cable management bracket only as an aid for balance.
Required Tools and Equipment
You need the following tools and part to perform this task:
• ESD-preventive strap
• Medium flat-blade or Phillips screwdriver
• Impedance carrier (Cisco Product number CRS-MSC-IMPEDENCE=)
Steps
To remove an MSC, FP, or LSP line card, see Figure 4-24 and follow these steps: