Filter
Top Products
4-22
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove a Switch Fabric Card
Figure 4-16 Removing a Pillow Block
Step 3
Remove the lower left screw (located below the pillow block pin). (See item number 3 in Figure 4-16.)
Step 4 Remove the top left screw (located above the pillow block pin). (See item number 4 in Figure 4-16.)
Step 5 Remove the pillow block and set it aside.
Step 6 Repeat this procedure for the card slot’s other pillow block if necessary.
What’s Next
After performing this task, you may install a new pillow block (see the “Installing a Pillow Block”
section on page 4-19).
How to Install or Remove a Switch Fabric Card
This section contains the following procedures:
• Installing a Switch Fabric Card, page 4-22
• Removing a Switch Fabric Card, page 4-26
• Verifying the Installation of a Switch Fabric Card, page 4-28
Installing a Switch Fabric Card
This section describes how to install a switch fabric card in the Cisco CRS 8-slot line card chassis. For
more detailed information on the switch fabric card, see Cisco CRS Series Carrier Routing System 8-Slot
Line Card Chassis System Description.
211480
4
2
1
3