Filter
Top Products
4-15
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
OL-6256-17
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove a Slot Cover
Step 3 Partially tighten the four captive screws on the front panel of the slot cover (either by hand or with the
screwdriver) to make sure that they are both engaged.
Step 4 To seat the slot cover firmly in place, fully tighten the captive screws.
What to Do Next
After performing this task, replace any rear (MSC) side cosmetic covers.
Removing a Slot Cover
This section describes how to remove a slot cover from the Cisco CRS 8-slot line card chassis. The
chassis is shipped with slot covers over the switch fabric card and RP card slots. Both slot cover types
are removed in the same manner. (Figure 4-13 shows a switch fabric slot cover for reference.) For more
detailed information on the slot covers, see the “Information About Impedance Carriers and Slot Covers”
section on page 4-6.
Figure 4-13 Switch Fabric Slot (Half Height) Slot Cover
122142