Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio transmit-power
101
Cisco IOS Release 12.1(5)XM
radio transmit-power
To set the transverter to transmit the specified amount of power (in dBm) when in operation, use the
radio transmit-power interface configuration command. To disable this function, use the no form of
this command.
radio transmit-power power-level
no radio transmit-power
Syntax Description
Defaults No default behavior or values.
Command Modes Interface configuration
Command History
Usage Guidelines Maximum transmission power is limited by the capabilities of the transverter. In addition, your
country’s telecommunications authority (the FCC in the United States) regulates the maximum power.
It is the responsibility of the installer and operator to comply with the relevant regulations.
To support the maximum number of users in an area, keep the power as low as possible while
maintaining sufficient margin and performance. Refer to the Cisco Broadband Fixed Wireless Site
Planning Guide for additional information.
Note The command takes effect on the next no shut.
Examples The following example shows how to set the transmit power to +25 dBm:
UBR04(config-if)# radio transmit-power 25
Related Commands
power-level Positive number representing power stated in dBm. Transmit power
range is between 4 and 33 dBm.
Release Modification
12.0(7)XR This command was introduced.
12.1(1)T Transmit power range was modified.
12.1(3)XQ1 Supported on the fixed wireless multipoint product.
Command Description
show controllers radio rf Displays the current transmit power settings.