Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
show controllers radio upstream
120
Cisco IOS Release 12.1(5)XM
show controllers radio upstream
To display upstream port information for a wireless modem card, use the show controllers radio
upstream EXEC command. To disable this function, use the no form of this command.
show controllers radio slot/upstream-port upstream
no show controller radio slot/upstream-port upstream
Syntax Description
Defaults No default behavior or values.
Command Modes EXEC
Command History
Examples The following example shows how to display information for upstream 0 in slot number 3, port number
0:
CMTS01# show controllers radio 3/0 0 upstream
Radio 3/0 Upstream 0 is up
Frequency 5.008 MHz, Channel Width 0.200 MHz, QPSK Symbol Rate 0.160 Msps
Spectrum Group 4
Nominal Input Power Level 5 dBmV, Tx Timing Offset 0
Ranging Backoff Start 16, Ranging Backoff End 16, Tx Backoff Start 16
Tx Backoff End 16, Modulation Profile Group 1
part_id=0x3137, rev_id=0x01, rev2_id=0xFF
nb_agc_thr=0x0000, nb_agc_nom=0x0000
Range Load Reg Size=0x58
Request Load Reg Size=0x0E
Minislot Size in number of Timebase Ticks is = 8
Minislot Size in Symbols =8
Bandwidth Requests = 0x0
Piggyback Requests = 0x0
Invalid BW Requests= 0x0
Minislots Requested= 0x0
Minislots Granted = 0x0
Minislot Size in Bytes = 2
UCD Count = 0
DES Ctrl Reg#0 = C00C0C43, Reg#1 = 0
slot/upstream-port Specifies the slot and upstream port numbers of the wireless modem card.
Release Modification
12.1(3)XQ1 This command was introduced.