Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio flap-list miss-threshold
47
Cisco IOS Release 12.1(5)XM
radio flap-list miss-threshold
To specify the miss threshold for recording a flap-list event, use the radio flap-list miss-threshold
global configuration command. A miss is the number of times a radio subscriber does not acknowledge
a MAC layer keep-alive message from a subscriber unit. When the number of misses exceeds the
threshold, the radio subscriber unit is placed in the flap list. To disable the miss threshold as a criterion
for adding a radio subscriber unit to the flap list, use the no form of this command.
radio flap-list miss-threshold threshold-num
no radio flap-list miss-threshold
Syntax Description
Defaults No default behavior or values.
Command Modes Global configuration
Command History
Examples The following example shows how to set the miss threshold to 50:
CMTS01(config)# radio flap-list miss-threshold 50
Related Commands
threshold-num The miss threshold value specified by the user. Any subscriber that misses
more than the specified number is placed in the flap list.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
clear radio flap-list Clears the current radio flap-list entries for a specific subscriber unit or all
subscriber units.
radio flap-list aging Specifies the number of days to record and retain flapping activity on a radio
subscriber unit in the flap-list table.
radio flap-list
insertion-time
Sets the radio flap list insertion time.
radio flap-list size Specifies the maximum number of the radio subscriber units to be reported
in the radio flap-list table.
show radio flap-list Displays the radio flap list of a wireless modem card.