Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio cable-loss
37
Cisco IOS Release 12.1(5)XM
radio cable-loss
To specify the effective cable loss (measured in dB) of the cable between the wireless card and the
specified wireless transverter, including the power feed panel, connectors, and lightning protection, use
the radio cable-loss interface configuration command. To remove the setting, use the no form of this
command.
radio cable-loss {auto | antenna_num tx_loss rx_loss}
no radio cable-loss
Syntax Description
Defaults No default behaviors or values.
Command Modes Interface configuration
Command History
auto The radio modem automatically determines the cable loss compensation for
the specified antenna.
antenna_num Enter 1 for the main antenna or 2 for the diversity antenna.
tx_loss Positive number (less than or equal to 15 dB) that reflects the effective
transmit cable loss at 330 MHz.
rx_loss Positive number (less than or equal to 13 dB) that reflects the effective
receive cable loss at 426 MHz.
Note The cable loss parameter cannot be set to a value greater than 13 dB for rx-loss and 15 dB for
tx_loss. The exact cable-loss value is determined by the transverter. The system compares this
value to the value when a no shut command is entered. To display the current cable loss
setting, use the show running-configuration interface radio command.
Release Modification
12.0(1)XR This command was introduced.
12.1(3)XQ1 Support for multipoint was added.