Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
pppoe forwarding group
31
Cisco IOS Release 12.1(5)XM
pppoe forwarding group
To set a PPP over Ethernet forwarding group number on the radio interface, use the forwarding group
interface configuration command. To disable forwarding group assignment, use the no form of this
command.
forwarding group group-num
no forwarding group group-num
Syntax Description
Defaults No default behaviors or values.
Command Modes Interface configuration
Command History
Usage Guidelines The forwarding group command needs to be set on both the radio interface and the ATM or permanent
virtual circuit (PVC) interface. The forwarding engine maintains an internal table of the forwarding
group. The forwarding group information from the internal table is used for forwarding packets between
the radio interfaces and the ATM or PVC interfaces. The group-num value needs to be the same on both
the radio and the ATM or PVC interfaces. For more information about configuring PPPoE on an ATM
or PVC interface refer to the PPP over Ethernet document.
Examples The following example shows how to set the PPPoE forwarding group number to 1 for the radio
interface:
Router(config-if)# forwarding group 1
The following example shows how to configure the forwarding group on the ATM or PVC interface:
router(config)# int atm2/0.1 p
router(config-subif)# pvc 0/60
router(config-if-atm-)# forwarding group 1
group-num Specifies PPPoE forwarding group number. Valid range is 1 to 10.
Release Modification
12.1(3)XQ1 This command was introduced.