Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
show interface radio tl-data
139
Cisco IOS Release 12.1(5)XM
show interface radio tl-data
To display the timeline data collected for the identified specifications, use the show interface radio
tl-data privileged EXEC command.
show interface radio slot/port tl-data [statsParams {MAC-address | chan-id}]
Syntax Description
Defaults No default behavior or values.
Command Modes Privileged EXEC
Command History
Examples The following example shows how to display the timeline data for sinr-ant1 on channel 0 for the radio
card in slot 6, port 0:
Router# show int radio 6/0 tl-data sinr-ant1 0
slot/port The slot and port numbers of the radio card.
statsParams {sinr-ant1 | sinr-ant2 | sinr-total | timingOffset | rf-rx-power-ant1
| rf-rx-power-ant2 | chan-delay-spread-ant1 |
chan-delay-spread-ant2 | power-amb}
The data for the radio attribute is collected as a histogram.
sinr-ant1 Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2 Signal-to-interference plus noise ratio for antenna 2.
sinr-total Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1 Represents the receive power at the main RF headend (antenna gain
is not included).
rf-rx-power-ant2 Represents the receive power at the diversity RF headend (antenna
gain is not included).
chan-delay-spread-ant1 The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2 The offset for channel delay spread on antenna 2.
power-amb Represents the noise floor of the ambient environment, in decibels.
MAC-address Specifies the MAC address for a particular subscriber unit.
chan-id Specifies an upstream channel ID.
Release Modification
12.1(3)XQ1 This command was introduced.