Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio arp
36
Cisco IOS Release 12.1(5)XM
radio arp
The Reverse Address Resolution Protocol (RARP) is an Internet protocol that is used to map IP
addresses to MAC addresses on computers and other equipment installed on the wireless network. To
activate RARP requests so that the Cisco uBR7200 series can perform IP address resolution on the
downstream path, use the radio arp interface configuration command. To disable, use the no form of
this command.
radio arp
no radio arp
Syntax Description This command has no arguments or keywords.
Defaults ARP is activated by default.
Command Modes Interface configuration
Command History
Examples The following example shows how to activate ARP requests:
Router(config-if)# radio arp
Related Commands
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
show running-config Shows if RARP has been activated or deactivated.