Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio timeline
98
Cisco IOS Release 12.1(5)XM
radio timeline
To configure a timeline collection specification, use the radio timeline interface configuration
command. To delete a timeline, use the no form of this command.
radio timeline statsParams {MAC-address | chan-id} size [dsp dspNum][print-options {on | off}]
[sampling-period] [tone {circular | average | number toneVal}]
[Trigger threshParams threshType postTrigBufmgt]
no radio timeline statsParams {MAC-address | chan-id}
Syntax Description statsParams {sinr-ant1 | sinr-ant2 | sinr-total | timingOffset | rf-rx-power-ant1
| rf-rx-power-ant2 | chan-delay-spread-ant1 |
chan-delay-spread-ant2 | power-amb}
The data for the radio attribute is collected as a histogram.
sinr-ant1 Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2 Signal-to-interference plus noise ratio for antenna 2.
sinr-total Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1 Represents the receive power at the main RF headend (antenna gain
is not included).
rf-rx-power-ant2 Represents the receive power at the diversity RF headend (antenna
gain is not included).
chan-delay-spread-ant1 The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2 The offset for channel delay spread on antenna 2.
power-amb Represents the noise floor of the ambient environment, in decibels.
MAC-address Specifies a particular subscriber unit.
chan-id Specifies an upstream channel ID. Valid values are 0 to 3.
size Specifies the number of values to be collected.
dsp Specifies one of the following digital signal process (DSP) dspNum
values: dsprx0, dsprx1, dsprx2, or dsprx3.
print-options on or off.
sampling-period Specifies, in seconds, the frequency of data collection.
Trigger Specifies when the collection of data must stop. Trigger identifies a
threshold specification. When the threshold is reached, the timeline
collection is stopped.
threshParams Has same attributes as statsParams.
threshType {high-thresh | low-thresh | up-change | down-change |
pos-crossing | neg-crossing}
high-thresh Specifies that the threshold condition is met when the value being
monitored is above threshValue.
low-thresh Specifies that the threshold condition is met when the value being
monitored is below threshValue.
up-change Specifies that the threshold condition is met when the positive change
of the value being monitored is greater than threshValue.