Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio upstream target-receive-power
112
Cisco IOS Release 12.1(5)XM
radio upstream target-receive-power
To set the desired target-receive power level, use the radio upstream target-receive-power interface
configuration command. To disable this function, use the no form of this command.
radio upstream usportnum target-receive-power power-level
no radio upstream usportnum target-receive-power
Syntax Description
Defaults The power-level parameter has a default value of -66.
Command Modes Interface configuration
Command History
Usage Guidelines The specified gain value must be within the range supported by the RF hardware. This command can
be entered only when the radio link is down (shut) and will take effect when the link becomes active
again (no shut).
Use the show controllers radio slot/port rf | if command to display the current target-receive power
settings for the RF and IF.
Examples The following example shows how to set the target-receive power level for upstream port 1 to -60:
UBR04(config-if)# radio upstream 1 target-receive-power -60
Related Commands
usportnum Specifies the upstream port number. Valid values are 0 to 3.
power-level Specifies the target-receive power level set by the user. Validvalues are -100
to -30. The default value is -66.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
show controllers radio
slot/port rf | if
Displays attributes about a particular modem card.