Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio modulation-profile
75
Cisco IOS Release 12.1(5)XM
radio modulation-profile
To create or modify modulation profiles, use the radio modulation-profile global configuration
command. To delete modulation profiles, use the no form of this command.
radio modulation-profile n [bandwidth bandwith | throughput throughput |
multipath-robustness | burst-length]
no radio modulation-profile
Syntax Description
Defaults See the syntax description above for the default settings.
Command Modes Global configuration
Command History
Usage Guidelines Use the show radio modulation-profile command to verify the modulation-profile settings that you
specified. You can apply modulation profiles to one or more upstream or downstream channels.
Examples The following example shows how to add a modulation profile:
Router(config)# radio modulation-profile 1 bandwidth 3.0 throughput 6.6
multipath-robustness high burst-length medium
Related Commands
n The modulation profile index number. The maximum profile number is 32.
Valid range is 1 to 32.
bandwidth bandwith Specifies the bandwidth in MHz. Valid entries are decimal numbers in the
range 0.0 to 100.0. The default value is 6.0 MHz.
throughput throughput Specifies the physical layer throughput in Mbps. Valid entries are integer
numbers 0 to 500. The default value is 10 Mbps.
multipath-robustness Specifies the multipath robustness level (delay spread tolerance). The valid
setting are standard | high. The default setting is high.
burst-length Specifies the duration of OFDM burst. Valid settings are short | medium |
long | very-short. The default setting is medium.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
show radio capability
modulation-profile
Displays all the profiles that the radio modem card supports.
show radio
modulation-profile
Displays the modulation-profile settings that you have specified.