Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio upstream data-backoff
103
Cisco IOS Release 12.1(5)XM
radio upstream data-backoff
To set fixed start and stop values for initial ranging backoff on the upstream port, use the radio
upstream data-backoff interface configuration command. To set the initial ranging backoff values to
the default start and end values, use the no form of this command.
radio upstream n data-backoff start-value end-value [auto]
no radio upstream n data-backoff
Syntax Description
Defaults The default initial ranging value is auto.
Command Modes Interface configuration
Command History
Examples The following example shows how to set the initial ranging start and end backoff values to 2 and 4,
respectively, for upstream port 2:
UBR(config-if)# radio upstream 2 data-backoff 2 4
Related Commands
n Specifies the upstream port number.
start-value Specifies the initial ranging start backoff value. Valid start values are 0 to
15; 0 is the default start value.
end-value Specifies the initial ranging end backoff value. Valid end values are 0 to 15;
4 is the default end value.
auto Specifies the automatic changed data backoff value.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
radio upstream
range-backoff
Sets the start and end ranging backoff values.