Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
pppoe forwarding default-qos-level
30
Cisco IOS Release 12.1(5)XM
pppoe forwarding default-qos-level
To set all packets received on the radio interface with a single quality-of-service (QoS) level, use the
forwarding default-qos-level radio interface configuration command. To disable PPPoE forwarding,
use the no form of this command.
forwarding default-qos-level qos-level-num
no forwarding default-qos-level qos-level-num
Syntax Description
Defaults No default behaviors or values.
Command Modes Interface configuration
Command History
Examples The following example shows how to set PPPoE forwarding default-qos-level value to 1:
Router(config-if)# forwarding default-qos-level 1
Related Commands
qos-level-num QoS level number to map to a virtual circuit (VC). Valid rage is 1 to
4,294,967,295.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
pppoe-forwarding Enables PPPoE forwarding on the radio interface.
forwarding group Sets a PPPoE forwarding group number on the router.
su-mac Specifies the subscriber unit MAC address that is mapped from the radio
interface to the virtual circuit (VC) on the ATM interface for PPPoE
forwarding.
tag Specifies the subscriber unit tag name that is mapped from the radio
interface onto the VC on the ATM interface for PPPoE forwarding.