Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio upstream range-backoff
107
Cisco IOS Release 12.1(5)XM
radio upstream range-backoff
To set fixed start and stop values for ranging backoff on the upstream ports, use the radio upstream
range-backoff interface configuration command. To set the ranging backoff values to the default start
and end values, use the no form of this command.
radio upstream n range-backoff start-value end-value[auto]
no radio upstream n range-backoff
Syntax Description
Defaults The default initial ranging value is auto.
Command Modes Interface configuration
Command History
Examples The following example shows how to set the start and end ranging backoff values to 2 and 4,
respectively, for upstream port 2:
UBR(config-if)# radio upstream 2 range-backoff 2 4
Related Commands
n Specifies the upstream port number.
start-value Specifies the start ranging backoff value. Valid start values are 0 to 15. The
default start value is 0.
end-value Specifies the end ranging backoff value. Valid end values are 0 to 15. The
default end value is 4.
auto Specifies the automatic change data backoff value.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
radio upstream
data-backoff
Sets the initial ranging start and end backoff values.