Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio threshold
96
Cisco IOS Release 12.1(5)XM
radio threshold
To configure a threshold specification, use the radio threshold interface configuration command. To
delete a threshold specification, use the no form of this command.
radio threshold statsParams {MAC-address | chan-id} threshType threshValue [repeat-time]
[clear-time][dsp dspNum]
no radio threshold statsParams threshType
Syntax Description statsParams {sinr-ant1 | sinr-ant2 | sinr-total | timingOffset | rf-rx-power-ant1 |
rf-rx-power-ant2 | chan-delay-spread-ant1 | chan-delay-spread-ant2 |
power-amb}
sinr-ant1 Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2 Signal-to-interference plus noise ratio for antenna 2.
sinr-total Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1 Represents the receive power at the main RF headend (antenna gain is not
included).
rf-rx-power-ant2 Represents the receive power at the diversity RF headend (antenna gain is
not included).
chan-delay-spread-ant1 The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2 The offset for channel delay spread on antenna 2.
power-amb Represents the noise floor of the ambient environment, in decibels.
MAC-address Specifies a particular subscriber unit.
chan-id Specifies an upstream channel ID. Valid values are 0 to 3.
threshType {high-thresh | low-thresh | up-change | down-change | pos-crossing |
neg-crossing}
high-thresh Specifies that the threshold condition is met when the value being
monitored is above threshValue.
low-thresh Specifies that the threshold condition is met when the value being
monitored is below threshValue.
up-change Specifies that the threshold condition is met when the positive change of
the value being monitored is greater than threshValue.
down-change Specifies that the threshold condition is met when the negative change of
the value being monitored is greater than the threshValue.
pos-crossing Specifies that the threshold condition is met when the value being
monitored does a positive crossing (positive increase) of the threshValue.
neg-crossing Specifies that the threshold condition is met when the value being
monitored does a negative crossing (negative increase) of the threshValue.
threshValue A 32-bit integer value.
repeat-time Identifies how much time is left before another event of the same type is
generated when oscillating across a threshold.