Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio interface radio rf-update duplexer
62
Cisco IOS Release 12.1(5)XM
radio interface radio rf-update duplexer
To set or update the radio frequency or wireless transverter duplexer information stored in the hardware,
use the radio interface radio rf-update duplexer privileged EXEC command.
radio interface radio slot/port rf-update duplexer {1 | 2} code-date Lo-bandStart Lo-bandEnd
Hi-bandStart Hi-bandEnd Tx-insertion-loss [Tx-lo | Tx-hi]
Syntax Description
Defaults No default behaviors and values.
Command Modes Privileged EXEC
slot/port Identifies the slot and port numbers.
1 | 2
Enter 1 for the main antenna or 2 for the diversity antenna.
code-date Identifies the date the duplexer information was last updated or reset. The
date must be specified in the mmddyyyy format. For single digit month and
date values, you need to zero-fill them. For example, for August 3, 2000,
you enter 08032000.
Lo-bandStart Identifies the duplexer’s start low-frequency range. Valid start low-band
pass is 0 to 65535 MHz. When setting the start low-frequency range for the
duplexer, this range of values must be lower than the range specified for the
Hi-bandStart parameter.
Lo-bandEnd Identifies the duplexer’s end low-frequency range. Valid end low-band pass
is 0 to 65535 MHz. When setting the end low-frequency range for the
duplexer, this range of values must be lower than the range specified for the
Hi-bandEnd parameter.
Hi-bandStart Identifies the duplexer’s start high-frequency range. Valid start high-band
pass is 0 to 65535 MHz. When setting start high-frequency range for the
duplexer, this range of values must be higher than the range specified in the
Lo-bandStart parameter.
Hi-bandEnd Identifies the duplexer’s end hi-frequency range. Valid end high-band pass
is 0 to 65535 MHz. When setting end hi-frequency range for the duplexer,
this range of values must be higher than the range specified in the
Lo-bandEnd parameter.
Tx-insertion-loss
Specifies the transmit insertion loss for the duplexer, in dB. The insertion
loss of the duplexer is the degree to which it attenuates the signal passing
through its pass-bands. Valid range is 0 255 dB.
Tx-lo Indicates that the low-frequency range is used for transmission, which
implies that the high-band frequency range is used for reception. Valid
frequency range is 0 to 65535 MHz.
Tx-hi Indicates that the high-frequency range is used for transmission, which
implies that the low-band frequency range is used for reception. Valid
frequency range is 0 to 65535 MHz.