Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio hist-display
50
Cisco IOS Release 12.1(5)XM
radio hist-display
To control the display of histogram data, use the radio hist-display interface configuration command.
radio histogram {[all] | {statsParams MAC-address | chan-id} on | off}
Syntax Description
Defaults By default the histogram display is on.
Command Modes Interface configuration
Command History
Examples The following example shows how to set the display of histogram data for sinr-ant1 on channel 0 to
OFF:
UBR04(config-if)# radio hist-display sinr-ant1 0 off
all Controls the display of all the histograms in the system.
statsParams {sinr-ant1 | sinr-ant2 | sinr-total | timingOffset | rf-rx-power-ant1
| rf-rx-power-ant2 | chan-delay-spread-ant1 |
chan-delay-spread-ant2 | power-amb}
sinr-ant1 Signal to interference plus noise ratio for antenna 1.
sinr-ant2 Signal to interference plus noise ratio for antenna 2.
sinr-total Signal to interference plus noise ratio for antennas 1 and 2.
timingOffset Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1 Represents the receive power at the main RF headend (antenna gain
is not included).
rf-rx-power-ant2 Represents the receive power at the diversity RF headend (antenna
gain is not included).
chan-delay-spread-ant1 The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2 The offset for channel delay spread on antenna 2.
power-amb Represents the noise floor of the ambient environment, in decibels.
MAC-address Specifies a particular subscriber unit.
chan-id Specifies an upstream channel ID. Valid values are 0 to 3.
on | off Specifies whether to turn the display of the histogram data on or off.
Release Modification
12.0(7)XR This command was introduced.
12.1(3)XQ1 Support for multipoint radio modem was added.