Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
pppoe su-mac
33
Cisco IOS Release 12.1(5)XM
pppoe su-mac
To to enable PPPoE forwarding on the radio interface using the subscriber unit’s MAC address, use the
su-mac global configuration command. To disable PPPoE specification, use the no form of this
command.
su-mac MAC-address qos-level level-num type {pppoe | all} [cos-id id-num | sid-index]
no su-mac MAC-address qos-level level-num type {pppoe | all} [cos-id id-num | sid-index]
Syntax Description
Defaults No default behaviors or values.
Command Modes Global configuration
Command History
Examples The following examples show how to associate subscriber unit MAC addresses to QoS-level numbers:
Router(config)# su-mac 0090.8330.0215 qod_level 1 type all cos_id 10
Router(config)# su-mac 0050.7366.1241 qos_level 2 type pppoe cos_id 16
Related Commands
MAC-address Specifies the subscriber unit MAC address.
qos-level level-num Specifies QoS level number to map to a virtual circuit (VC). The range for
level-num is 1 to 1024.
type {pppoe | all} Specifies packet fowarding options as either pppoe or all.
pppoe Specifies that only pppoe packets are allowed to forwarding.
all Specifies that all packets allowed to forwarding.
cos-id id-num Optional class-of-service identifier specification in TFTP configuration file.
Valid range is 1 to 16.
sid-index Creates service identifier index in an internal table.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
pppoe-forwarding Enables PPPoE forwarding on the radio interface.
forwarding
default-qos-level
Sets all packets received on the radio interface with a single
quality-of-service (QoS) level.
forwarding group Sets a PPPoE forwarding group number on the radio interface.
tag Specifies the subscriber unit tag name that is mapped from the radio
interface onto the VC on the ATM interface for PPPoE forwarding.