Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
Command Reference
17
Cisco IOS Release 12.1(5)XM
Command Reference
This section documents the new commands associated with the fixed wireless multipoint feature. All
other commands used with this feature are documented in the Cisco IOS Release 12.1 command
reference publications. The commands are classified into the following groups:
• Startup Commands
• Installation and Configuration Commands
• Verification Commands
• Operating Commands
• Monitoring Commands
• Troubleshooting Commands
Note This classification is created to help the user in chunking the commands. Some of the
commands can be listed under any of these groups.
Startup Commands
Use the following commands to startup your fixed wireless multipoint headend system. Note that these
commands are not specific to this feature; they are Cisco IOS generic commands, and their syntax can
be found in the command reference documentation for Cisco IOS Release 12.1, available on CCO and
the Documentation CD-ROM.
• show running-configuration
• show start-up configuration
• shut
• write
Installation and Configuration Commands
Use the following commands to install and configure your fixed wireless multipoint headend system:
• loopback
• microcode reload
• radio arp
• radio cable-loss
• radio downstream annex B
• radio downstream frequency
• radio downstream subchannel modulation-profile
• radio helper-address
• radio insertion-interval
• radio interface radio rf-update duplexer
• radio modulation-profile
• radio receive-antennas