Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio snapshot
93
Cisco IOS Release 12.1(5)XM
Defaults No default behavior or values.
Command Modes Interface configuration
Command History
Usage Guidelines A snapshot is a specified amount of data captured from the wireless modem card.
When you issue a snapshot request, as many as four simultaneous radio signal attributes can be
captured. The four attributes are specified by the bitwise OR operation data of as many as four of the
snapshot types.
Examples The following example shows how to create a snapshot specification for dsprx0:
Router(config-if)# radio snapshot dsprx0 1 initial-ranging
maint-range
Keeps the link between a subscriber unit and headend “alive” even if
data is not being transmitted. Snapshot is taken when a stationary range
burst is received.
sm-data
Keeps the link between a subscriber unit and headend “alive” even if
data is not being transmitted. Snapshot is taken when a stationary rang-
ing data burst is received.
ra
Snapshot is taken when request access burst is received.
power
Snapshot is taken when automatic level control (ALC) burst is received.
null
Snapshot is taken when NULL burst is received. It measures ambient
and calibration noise.
short-data
Snapshot is taken when data burst is received. It measures the actual
traffic burst.
long-data
Snapshot is taken when data burst is received. It measures the actual
traffic burst.
inr-data
Snapshot is taken when initial range data burst is received.
cable-pad
Snapshot is taken when cable-pad burst is received.
Release Modification
12.1(3)XQ1 This command was introduced.