Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio proxy-arp
81
Cisco IOS Release 12.1(5)XM
radio proxy-arp
To activate the radio proxy Address Resolution Protocol (ARP) for host-to-host communications, use
the radio proxy-arp interface configuration command. The radio proxy ARP enables the Cisco
uBR7200 series to issue ARP requests on behalf of the subscriber units on the same wireless network
subnet. To disable this feature, use the no form of this command.
radio proxy-arp
no radio proxy-arp
Syntax Description This command has no arguments or keywords.
Defaults Enabled
Command Modes Interface configuration
Command History
Usage Guidelines To verify if radio proxy ARP has been activated or deactivated, enter the show running-config
command and look for the interface configuration information. If radio proxy ARP has been activated,
it does not appear in this output. If radio proxy ARP has been deactivated, it appears in the output as no
radio proxy-arp. If you are having trouble, make sure that you entered the correct port and radio
modem card slot number when you activated radio proxy ARP.
Examples The following example shows how to activate proxy ARP for host-to-host communications:
CMTS01(config-if)# radio proxy-arp
Release Modification
12.1(3)XQ1 This command was introduced.